ProGraphics 3D Ultra III
Model No. MVGA-I740AG, MVGA-I740AN |
| |
|
| Issue List |
| Q1-1: |
Why
can't I install the VGA driver to Windows 95/98? |
| Q1-2: |
Why
the system will be hang under socket 7 motherboards? |
| Q1-3: |
Why
the monitor device will be detected by "Default Monitor"? |
| Q1-4: |
Why
can't I install the VGA driver on Windows 95? |
| Q1-5: |
Why
can't I install the driver on Windows NT? |
| |
|
| Common Issues |
| Q1-1: |
Why
can't I install the VGA driver to Windows 95/98? |
| A1-1: |
Before
installing the VGA card driver, you must change VGA driver to
[Standard PCI Graghics Adapter]. And then re-install your VGA
driver again. |
|
|
| Q1-2: |
Why
the system will be hang under socket 7 motherboards? |
| A1-2: |
It
is a compatible issue. Actually, it is happened at all socket
7 motherboards with AGP. Please contact with your motherboard
vender or the chipset vender to get this driver for Intel I740. |
|
|
| Q1-3: |
Why
the monitor device will be detected by "Default Monitor"? |
| A1-3: |
Please
check your monitor's specification. Some monitors connect the
DDC signal to ground, Which causes the BIOS can not detect your
monitor. Therefore, it will cause your Intel740 can not get
any data or refresh rates. To fix the problem: You have to open
(remove the jumpers) from JP5 &JP6. The default settings
of JP5 & JP6 are closed. |
|
|
| Q1-4: |
Why
can't I install the VGA driver on Windows 95? |
| A1-4: |
If
your operating system isn't the OSR2.1 version, the driver won't
install. Please make sure your Windows'95 is OSR2.1 or later
version. |
|
|
| Q1-5: |
Why
can't I install the driver on Windows NT? |
| A1-5: |
You
haven't installed the SP3 or later for windows NT4.0. So the
I740 does not detect it and it won't load the driver. To fix
the problem: Please download the SP3 from the Microsoft's website
and install it. |
| |
|
